Weights, as the standard for measuring the quality of items, have high requirements for accuracy. If there are errors when using them, the following methods can be used to solve them. Let's follow the staff of cast iron weights to take a look!

1. Place the weights as much as possible in the prepared box before and after use. Do not place the weights directly on the table or throw them on the floor. (Wet and dusty under the table)

Causing wear and damage to the correct weight.

2. To prevent rusting, wipe the rusted weights with industrial alcohol to remove rust spots, and then place them in a well ventilated area. On the other hand, this is the reason

3. If there are doubts about the quality of the weights, they can be tested using factory (third-party calibrated) electronic scales or electronic scales. If there are errors in the weights, they can be

The combination of scales and weights, and the introduction of scales and weights with different levels:

Cast iron weight

Customized cast iron weights

The management of weights, for example, weights cannot be directly held by hand and should be stored in a dry and clean place.

Weights, as measuring equipment, have always been good partners with scales. Various materials such as stainless steel, cast iron, paint, etc. The quality and size of different materials also vary, but one side needs to be fine.

Weights are a measuring tool that, due to differences in materials, can pay more attention to various aspects such as stainless steel, chromium, and cast iron, making them longer. Now let's take a look, please remember to keep the weights in their original packaging; Place the weight next to the balance and handle it carefully; Please follow OIML/ASTM recommendations for cleaning; Use a clamp to operate larger weights; Avoid work that may damage the test weight; Do not touch the weight with your bare hands; Don't forget to make regular corrections; Do not use weights with dust or water on the surface; If there are any issues, please do not use weights; Do not use abrasive or corrosive chemicals for cleaning.

The above content mainly explains the solutions to the error problem of cast iron weights. I believe that after reading this article, everyone will also have a certain understanding of this. This is the end of the article's explanation. For more exciting content, we will see you in the next issue